搜索
100T主要性能与参数100T主要性能与参数项目数值最大额定总起重量100000kg基本臂最大起重力矩3238kN.m最长主臂+副臂最大起重力矩1127kN.m主臂最大起升高度48m主臂+副臂最大起升高度62.1m外形尺寸(长×宽×高)14550×2750×3750mm主臂长12.8-48m副臂长18.1m100T主要性能与参数起重特性表PATEDLIFTINGCAPACITYTABLE单位（UNIT）：Kg工作幅度WORKINGRADIUS（m）主臂BOOM主臂仰角BOOMANGLE（°）主臂+副臂BOOM+JIB支腿全伸、后方、侧方作业REAR&SIDEWORKINGAREAWITHOUTRIGGERFULLYEXTENDED45+9.5m45+16.0m臂长BOOMLENGTH副臂安装角JIBOFFSET副臂安装角JIBOFFSET12．0m16．2m20．4m27．0m33．0m39．0m45．0m5°30°5°30°3.0100000700008060002500400013003.59200070000580007855002400360012004.08500070000540007650002300320011504.5760006400051000350007445002200300011005.0700005800049000350007240002100270010505.563000510004500035000260007037002050250010006.05700046000430003400026000683400195024009506.5480004300041000330002600020000663200190022009007.0440004000039000320002600020000642900185021008507.537000370003500030500250002000015000622400180018008008.03400034000320002900040001900015000602000175015007509.0270002700027000250002250017500150005816001500120070010.02190021900022000205001650015000561400135011.018400190001950018000155001400012.015700160001650016000145001360014.01160001280013500130001200016.08400980010500110001050018.06300780082008500900020.0600066007200750022.0500052005800620024.042004800520026.03800430028.03100360030.02900说明（NOTE）：以上作业工况均为支腿全伸，不允许在不打支腿的情况下吊重。（Aboveworkingconditionisallwithoutriggerfullyextended,neverliftaloadonthewheels.）表中粗线以上数值是由起重机的结构强度所决定的，粗线以下数值是由起重机整机稳定性所决定的。(Capacitiesabovethethicklineinthetablearebasedontheboomstrength,theothers,onstablitiyofthe100T主要性能与参数completemachine.)打好第五支腿时，表中数值适用于圆周360°作业。(Withthe5thoutriggerfullyextended,full360rotationisavailableaccordingtothevalueslistedintheabovetable.)表中所列额定起重量为最大允许值，并包括吊钩重量（100吨吊钩重815Kg，60吨吊钩重560Kg，6吨吊钩重180Kg）和其他吊具的重量。(Theratedliftingcapacitylistedinthetableismax.allowedvalue,includingweightofthehookblock(thehookblockweightis815kgfor100t,560kgfor60t,180kgfor6t)andotherslings.)表中所给幅度值，是指吊载后吊钩中心到回转中心的水平距离。(Aworkingradiusgiveninthetableisahorizontaltotheaxisoftheslewingringwhenthehookblockisloaded.)当实际臂长和工作幅度在两数值之间时，应按最大臂长和幅度值确定起重量。(Whenactualboomlengthisbetweentwovalues,determingliftingcapacityaccordingtobiggerboomandradius.)在副臂伸出的情况下使用主臂作业时，额定起重量不仅要扣除吊具的重量，还要扣除2250Kg。(Ratedliftingcapacityshouldexcludetheweightofclingsand2250kg,whentheboomisusedwithjibextended.)