电缆分支箱技术协议

国家电网公司集中规模招标采购（总部统一组织，网省公司具体实施）2011年第六批项目许昌供电公司新兴路10千伏架空线路入地改造工程（10kV）（电缆分支箱）A400-500061964-00002技术协议许昌供电公司许昌电力设计院有限公司南阳飞龙电器制造有限公司2012年2月目次1标准技术参数表·············································································································2项目需求部分················································································································2.1货物需求及供货范围一览表·······························································································2.2必备的备品备件、专用工具和仪器仪表··················································································2.3图纸资料提交单位·········································································································2.4工程概况···················································································································2.5使用条件···················································································································2.6项目单位可选技术参数····································································································2.7项目单位技术差异·········································································································3投标人响应部分·············································································································3.1技术偏差表·················································································································3.2投标产品的销售及运行业绩表····························································································3.3投标人需提供的设备图纸及资料·························································································3.4主要组部件材料···········································································································3.5推荐的备品备件、专用工具和仪器仪表供货表··········································································1标准技术参数表投标人应认真逐项填写技术参数响应表中投标人保证值，不能空格，也不能以“响应”两字代替，不允许改动招标人要求值。如有偏差，应填写技术偏差表。“投标人保证值”应与型式试验报告相符。表1技术参数响应表序号名称单位招标人要求值投标人保证值一电缆分支箱共用参数1额定工作电压kV121221min工频耐压kV42423雷电冲击耐压kV75754额定频率Hz50505额定电流A6306306额定短时耐受电流（2s）kA20207额定峰值耐受电流kA50508额定负载开断电流A6306309回路电阻µΩ（投标人填写）（投标人填写）10外壳防护等级IP33IP33二外壳参数1材质（项目单位填写）不锈钢2厚度mm（项目单位填写）23颜色（项目单位填写）绿三负荷开关参数1额定电压kV121221min工频耐压kV对地42，断口48对地42，断口483雷电冲击耐压kV对地75，断口8575对地75，断口85754额定电流充电开断电流A10105额定频率Hz50506额定电流A6306307额定短时耐受电流（2s）kA20208额定峰值耐受电流kA50509额定短路关合电流kA505010额定负载开断电流A63063011额定闭环开断电流A63063012电气寿命次20020013机械寿命次5000500014回路电阻µΩ（投标人填写）（投标人填写）15导体材质T2铜T2铜表1（续）序号名称单位招标人要求值投标人保证值16套管导体直径mm≥30≥3017控制合辅助回路1min工频耐压V2000200018操动机构型式手动手动四电缆附件参数1额定相对地电压（U0）kV8.78.72额定电压（U）kV15153最高工作电压（Um）kV17.517.54局部放电水平（15kV）pC≤10≤105屏蔽电阻kΩ≤50≤506屏蔽泄漏电流mA≤0.5≤0.567结构类型屏蔽型可分离连接器屏蔽型可分离连接器78导体连接方式（螺栓式或插入式）螺栓式螺栓式89外屏蔽层接地电线截面积mm22.5五避雷器参数1额定电压kV17172最大持续运行电压kV13.613.63标称放电电流kA554直流1mA参考电压kV≥24≥2450.75U1mADC泄漏电流µA≤50≤5065kA标称放电电流下残压kV45/5045/5072ms方波通量电流A1501508大电流冲击耐受能力kA65652项目需求部分2.1货物需求及供货范围一览表表2货物需求及供货范围一览表序号设备名称单位项目单位要求投标人响应型式、规格数量型式、规格数量1电缆分支箱，AC10KV，SF6负荷开关，6路，630A台12kV带开关(电缆分支箱,AC10kV,SF6负荷开关,六路,630A)见附图所示（普通分接箱），包含图中相关其他配置1612kV带开关(电缆分支箱,AC10kV,SF6负荷开关,六路,630A)见附图所示（普通分接箱），包含图中相关其他配置162台12kV(电缆分支箱,AC10kV,两断路器,两负荷开关、六路,630A)（环分箱）见附图所示，包含图中相关其他配置。312kV(电缆分支箱,AC10kV,两断路器,两负荷开关、六路,630A)（环分箱）见附图所示，包含图中相关其他配置。33452.2必备的备品备件、专用工具和仪器仪表表3必备的备品备件、专用工具和仪器仪表供货表序号名称项目单位要求投标人响应规格单位数量规格单位数量12342.3图纸资料提交单位表4卖方提交的图纸资料及其接收单位提交图纸资料名称接收图纸单位名称、地址、邮编、电话提交份数提交时间图纸类许昌鲲鹏电力设计咨询有限公司许昌市莲城大道288号4610000374261644821）技术协议签订后2周内，供货商应提供认可图纸。2）工程师在收到认可图纸后2周内，应将经确认的1份图纸寄送给供货商安装使用说明书试验报告其他资料图纸类许昌供电公司许昌市莲城大道288号4610000374261643321）技术协议签订后2周内，供货商应提供认可图纸。2）工程师在收到认可图纸后2周内，应将经确认的1份图纸寄送给供货商安装使用说明书试验报告其他资料2.4工程概况2.4.1项目名称：新兴路10千伏架空线路入地改造项目2.4.2项目单位：许昌供电公司2.4.3工程规模：共用分接箱19台。2.4.4工程地址：新兴路2.4.5交通、运输：公路、铁路2.4.6工程布置：电缆线路配套2.4.7电气主接线：见附图2.4.7电气主接线：单环网。2.4.8电力系统情况：中性点不直接接地。1）系统标称电压：10kV。2）系统最高电压：12kV。3）系统额定频率：50Hz。4）安装地点：户外。2.5使用条件表5使用条件序号名称单位标准参数值项目单位要求值投标人保证值1周围空气温度最高气温℃+40+40+40最低气温252525最大日温差K252525表5（续）序号名称单位标准参数值项目单位要求值投标人保证值2海拔m≤1000≤1000≤10003太阳辐射强度W∕cm20.10.10.14污秽等级IIIIIIIII5覆冰厚度mm1010106风速/风压m/s/Pa34/70034/70034/7007湿度日相对湿度平均值％≤95月相对湿度平均值≤908耐受地震能力（水平加速度）m/s20.2g0.2g0.2g9由于主回路中的开合操作在辅助和控制回路上所感应的共模电压的幅值kV≤1.6≤1.6≤1.6注表中“项目单位要求值”为正常使用条件，超出此值时为特殊使用条件，项目单位可根据工程实际使用条件进行修改。2.6项目单位可选技术参数项目单位应根据实际工程情况认真填写相应的技术参数响应表中可选择部分。表6项目单位可选技术参数表序号名称单位招标人要求值投标人保证值1外壳材质不锈钢不锈钢2外壳厚度mm223箱体颜色绿绿4导体连接方式（螺栓式或插入式）螺栓式螺栓式52.7项目单位技术差异项目单位原则上不能改动通用部分技术条款及专用部分标准技术参数值，根据工程实际情况，如有差异，应逐项在项目单位技术差异表中列出。表7项目单位技术差异表（本表是对技术规范的补充和修改，如有冲突，应以本表为准）序号项目标准参数值项目单位要求值投标人保证值12……序号项目变更条款页码、款号原表达变更后表达12……3投标人响应部分3.1技术偏差表投标人应逐项响应本采购标准规范中的要求，如有与本规范要求不一致的地方，应逐项在投标人技术偏差表中列出。表8投标人技术偏差表序号项目对应条款编号技术规范书要求偏差备注12343.2投标产品的销售及运行业绩表表9投标产品的销售及运行业绩表（近五年）序号型号额定电压额定电流回路数工程名称数量投运时间使用单位联系人联系电话3.3投标人需提供的设备图纸及资料投标文件中投标人应提供以下图纸及资料1）电气主接线图。2）外形尺寸图。3）电缆分支箱详细的一次接线图及布置图。3.4主要组部件材料表10主要组部件材料表产品型号组部件名称供应商名称原产地备注外壳SF6负荷开关电缆附件避雷器带电指示器3.5推荐的备品备件、专用工具和仪器仪表供货表表11推荐的备品备件、专用工具和仪器仪表供货表（投标人填写）序号名称型号和规格单位数量制造商1234需方:许昌供电公司（盖章）设计方:许昌电力设计有限公司（盖章）代表：代表：电话：电话：传真：传真：E-mail：E-mail：日期：日期：供方:南阳飞龙电器制造有限公司（盖章）代表：文艺电话：0377-6156165513608459398传真：[phone]E-mail：[e-mail]日期：2012.2.13